Home › Forums › Hardware › Hardware Design & Discussion › Main board mounting holes…

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • JohnP
    Participant
    January 2, 2013 at 5:34 am
    Post count: 4
    #3585

    When/if you rev the main board, can you make the mounting holes a bit bigger (for 4/40 screws rather than 2/56) and keep other traces away from the holes so mounting hardware doesn’t short things out? I know things are tight, but it is hard to mount an osPID to a front panel with the crowded holes, USB and LCD…

    -John

    rocketscream
    Keymaster
    January 6, 2013 at 9:12 am
    Post count: 65
    #3981

    Hi John,

    I’m using metric measurement rather than imperial, the holes are for M2 screws basically.
    Yes, it is very tight but I will definitely move any traces close to those holes in the next revision.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.